Free shipping on orders over $49
Takaisin blogiin
Tuotearvostelut 2026-11-20 Audio Advisor | Turntables, Speakers, Headphones & Hi-Fi Equipment 0 katselukertaa

audiolab DC Block 6: Stop Amp Hum & Clean Mains Noise

audiolab DC Block 6: Stop Amp Hum & Clean Mains Noise

Learn how the audiolab DC Block 6 removes DC offset from your AC mains to eliminate toroidal transformer hum and reduce RFI/EMI noise across your entire hi-fi system.

Why Your Amp Hum Is a Mains Problem

The AC power from your wall should be a clean 60 Hz sine wave. In practice, household appliances like dimmer switches, hair dryers, and LED drivers draw current asymmetrically, creating a small DC offset—typically under 500 mV—riding on the AC line. This offset pushes toroidal power transformers in amplifiers toward magnetic saturation, causing them to vibrate mechanically. The result is a buzz or hum you can hear from the chassis, even with the volume off.

What the DC Block 6 Actually Does

  • audiolab DC Block 6 Direct Current Blocker - Black: The DC Block is a simple, purpose-built device that sits between your wall outlet and your amplifier (or your whole rack, for the DC Block 6) and removes the DC offset from the AC line. It rebalances the waveform so the positive and negative halves are symmetrical again. With the DC gone, your toroidal transformer stops saturating, the mechanical hum drops away, and the amp's power supply returns to operating efficiently. The DC Block 6 also includes a high-performance audio-class filter that attenuates RFI/EMI on the AC line.
    audiolab DC Block 6 Direct Current Blocker - Black
    audiolab DC Block 6 Direct Current Blocker - Black

Six Outlets, One Rack-Mount Solution

The DC Block 6 packs DC removal and RFI/EMI filtering into a 17.4-inch-wide rack chassis with six independent IEC outlets. It does everything the single DC Block does but lets you wire up your entire system in an afternoon. The unit is rated for a total combined load of 10 amps, with each outlet rated to 8 amps—plenty for a full rack of sources, preamp, and amplifiers.

What the DC Block 6 Is Not

This is a targeted tool for DC offset and RFI/EMI, not a surge protector. It has no MOVs, no joule rating, and no transient voltage suppression circuit. It will not protect your equipment from a lightning strike or a major line surge. If your amp doesn't hum and your system sounds clean, the improvement from RFI/EMI filtering alone will be more subtle—a small lift in dynamics and clarity.

Installation in Three Moves

  1. Unplug your component's power cable from the wall: No tools or rewiring needed—just access to the back of your gear.
  2. Plug the DC Block's cable into the wall: Use the supplied IEC cable to connect the unit to your wall outlet.
  3. Plug your component's cable into the DC Block's IEC outlet: Repeat for each of the six outlets. The whole rack can be wired in an afternoon.

When to Expect the Most Benefit

The clearest signal that you have DC on the mains is a mechanical hum coming from your amplifier's chassis—a buzz you can hear when the room is quiet, even with the volume all the way down or the amp in standby. If your amp hums, the DC Block 6 will likely eliminate it. If it doesn't, the improvement from RFI/EMI filtering will be smaller but still audible as cleaner dynamics and imaging.

Aiheeseen liittyvät artikkelit

Customer Service
Koti
Tuotteet
Ostoskori
Profiili