Get answers about the AC Infinity Aircom S8 component cooling fan: setup, noise, compatibility, and whether it fits your AV rack or cabinet.
What Is the AC Infinity Aircom S8?
What does the Aircom S8 do?
The AC Infinity AIRCOM S8 is a 17-inch component cooling fan that sits on top of a receiver or amplifier. Three dual-ball bearing blowers pull heat out of the component and push it out the back, keeping your gear from overheating in a cabinet or on a tight shelf.
How does it work?
It uses three blowers to draw heat from the vents of your AV component and exhaust it out the rear. The front controller lets you choose between ON, AUTO, SMART, and OFF modes, plus four speed levels. In AUTO, fans start at 88°F and stop at 84°F. In SMART, they adjust speed step by step as temperature drops.
Key Specifications at a Glance
AC Infinity Aircom S8 - Component Cooling System: Three dual-ball bearing blowers deliver up to 160 CFM at a rated 24 dBA. The high airflow keeps even hot-running receivers cool, while the low noise means you won't hear it during movies or music.
AC Infinity Aircom S8 - Component Cooling System
AC Infinity Aircom S8 - Component Cooling System: The steel chassis is 1.5 inches tall and can support up to 30 pounds of gear on top. You can stack another component—like a power conditioner or amplifier—directly on the fan, saving shelf space.
AC Infinity Aircom S8 - Component Cooling System: Setup takes minutes: plug in the included 6-foot power adapter, place the fan on the component, and press a button. No wiring, no software, and no drilling means anyone can install it without technical help.
Setup and Compatibility
How do I set up the Aircom S8?
Plug the included 6-foot power adapter into a wall outlet or power conditioner, then into the jack on the back of the fan. Set the fan on top of your receiver or amplifier with the exhaust facing the back of the cabinet. Press Mode to select AUTO or SMART, then Speed to choose a level. Settings survive a power outage.
Does my cabinet need ventilation?
Yes. The AIRCOM S8 pushes warm air out the back, so your cabinet needs a rear opening for that air to escape. It is not suitable for fully sealed cabinets. If yours is sealed, consider an open rack from the audio racks category.
Will it fit my receiver or amplifier?
The AIRCOM S8 is 17 inches wide—designed for full-width receivers, processors, and amplifiers. It sits on top of the component, so measure the width of your gear to ensure a good fit. The steel frame can carry up to 30 pounds of equipment stacked on top.
Noise, Power, and Maintenance
How loud is the Aircom S8?
AC Infinity rates it at 24 dBA at full speed. In SMART mode, the blowers slow down as the temperature drops, so they run quieter most of the time. The blowers are mounted on silicone to reduce vibration noise.
How much power does it draw?
The unit draws 8.8 watts from a 12-volt adapter. That's minimal—comparable to a small LED light—so it won't add noticeable heat or cost to your system.
What about reliability?
Each blower uses a PWM-controlled motor with dual ball bearings rated for 67,000 hours of life. The steel chassis is built from aluminum and cold-rolled steel. Settings persist through power outages, so you don't have to reconfigure after a brownout.
Liittyvät tuotteet
AC Infinity Aircom S8 - komponenttien jäähdytysjärjestelmä